ZyXEL Communications MSC1000G - Page 760

Chapter 29 port Commands
Management Switch Card User’s Guide
760
set <slot-port>
<etype> <vid>
<priority>
Adds the VLAN ID and 802.1p priority to untagged
frames with the specified Ethernet type.
8
qratelimit <slot-port> <profile>
Assigns a profile of per-queue rate limiting
parameters to the specified port.
8
qschedule <slot-port> [<spq> |
<wrr <wt0> <wt1>
<wt2> <wt3> <wt4>
<wt5> <wt6> <wt7>>]
Sets the port’s Class of Service (CoS) scheduling
method. SPQ (Strict Priority Queuing) services
queues based on the traffic’s IEEE 802.1p priority.
WRR (Weighted Round Robin) gives queues with
larger weights more service. wt0 - wt7 set the
priority weight (0~15) of each IEEE 802.1p priority
queue.
8
pvid <slot-port> <vid>
Sets the port VID on the Ethernet subscriber
port(s).
8
ratelimit <slot-port> <rate-
limit_profile>
Sets the specified Ethernet port(s) to use a profile
of egress and ingress rate settings.
8
speed <slot-port> <speed>
Sets the Ethernet port’s speed.
speed: auto|1000f|100f where f means full duplex.
Note: The port enet speed command only
supports the GLC1320G-55 line cards.
8
sfptx enable <slot-port>
Enables SFP slot transmission on the specified
Ethernet port.
Note: These port enet sfptx commands only
support the GLC1320G-55 line cards.
8
disable <slot-port>
Disables SFP slot transmission on the specified
Ethernet port.
8
tls disable <slot-port>
Disables Transparent LAN Service (TLS) on the
specified Ethernet subscriber port(s). The system
does not insert additional VLAN tags to packets.
8
enable <slot-port>
Turns on TLS to insert additional VLAN tags to
packets.
8
set <slot-port>
<svid> <spriority>
Sets/changes TLS settings on the specified
Ethernet subscriber port(s).
svid: The service provider VLAN ID.
spriority: The service provider IEEE 802.1p
priority setting.
8
show <slot>|<slot-
port>|<slot-port-
vpi/vci>
Displays the TLS settings of the specified slot,
Ethernet subscriber ports, or PVC.
<slot> : example: 3, *
<slot-port>: example: 3-1, 3-*
<slot-port-vpi/vci>: example: 3-1-0/33, 3-1-*,
3-*-*
1
vlan <slot-port> <vid>
<registration> <tag>
Sets the VLAN attributes of the specified Ethernet
subscriber port(s).
8
Table 364 port Commands (continued)
COMMAND DESCRIPTION P