ZyXEL Communications MSC1000G - Page 761

Chapter 29 port Commands
Management Switch Card User’s Guide
761
xvlan delete <slot-port>
<cvid>
Removes the specified XVLAN entry (cvid) from the
specified port.
Note: These port enet xvlan commands only
support the GLC1320G-55 line cards.
8
set <slot-port>
<cvid> <svid>
Creates an XVLAN entry for the specified port.
cvid is the original customer VLAN ID. When the
port receives traffic from the subscriber with a
cvid VLAN tag, XVLAN changes it to the svid
before forwarding it to the service provider’s
network.
8
show <slot-port>
Displays the XVLAN settings for the specified port. 8
gbond delete <slot> <bond_name>
Removes G.bond settings from the DSL lines
specified in the G.bond group.
bond_name: The name of a DSL line group with
G.bond configured on them.
8
set set <slot>
<bond_name>
<portlist>
Configures a G.bond group or modifies the
membership of a G.bond group.
portlist: A list of ports, for example, (1,2),
(5~7).
8
show <slot> [<bond_name>]
Shows G.bond settings on the specified port. 1
h248 set <slot-port>
<dsp_profile>
[dataprofile
<data_profile>]
Sets which DSP (Digital Sound Processing) profile
the specified H.248 ports use for voice traffic. You
can also set the DSP profile for data (fax and
modem) traffic.
8
termination <slot-port> <name>
[<step>]
Sets termination names for H.248 ports. 8
ipbpvc arpproxy flush all |edgerouter
[<ip-address> <vid>]
|interface [<ip/mask>
<vid>]
Manually flushes the learned MAC addresses from
the ARP table.
8
age <sec>
Sets the valid time interval for learned MAC
addresses in the ARP table (10~10000 in
seconds).
8
show
Displays the number of seconds a learned MAC
address remains valid in the ARP table.
8
delete <slot-port-vpi/vci>
Removes the specified IP aware Bridge PVC. 8
domain delete <domain-name>
Removes the specified domain. First delete all
VLANs belonging to this domain.
8
dhcpvlan disable
<domain name>
Disables DHCP VLAN in a domain. 8
dhcpvlan enable
<domain name> <vid>
Enables DHCP VLAN in a domain. 8
set <domain name>
Creates a domain with maximum 8 domains in the
system.
8
show[<domain name>]
Displays domain settings. 1
vlan <domain name>
<vid> <registration>
Sets a VLAN to join or leave a specified domain
with maximum 8 VLANs in one domain.
8
Table 364 port Commands (continued)
COMMAND DESCRIPTION P