Daedong CK22 - Flywheel and Main Bearing Case Cover

2-59
DS35-W00 May. 2007
CLUTCHCLUTCH CLUTCHCLUTCH
CLUTCH
TRANSMISSIONTRANSMISSION TRANSMISSIONTRANSMISSION
TRANSMISSION
ENGINEENGINE ENGINEENGINE
ENGINE
FRONT AXLEFRONT AXLE FRONT AXLEFRONT AXLE
FRONT AXLE
STEERINGSTEERING STEERINGSTEERING
STEERING
BARKEBARKE BARKEBARKE
BARKE
ELECTRICELECTRIC ELECTRICELECTRIC
ELECTRIC
INDEXINDEX INDEXINDEX
INDEX
HYDRAULICHYDRAULIC HYDRAULICHYDRAULIC
HYDRAULIC
GENERALGENERAL GENERALGENERAL
GENERAL
REAR AXLEREAR AXLE REAR AXLEREAR AXLE
REAR AXLE
HSTHST HSTHST
HST
CK22/CK22H
7.1.11 FLYWHEEL AND MAIN BEARING
CASE COVER
A. FLYWHEEL AND REAR PLATE
1. Loosen the flywheel bolt and remove the flywheel.
2. Loosen the bolt and remove the rear plate.
(When reassembling)
• Check the end of crankshaft any uneven wear, lack
or crack of teeth.
• Clean the end of crankshaft and the mating surface
of the flywheel.
• Apply oil to flywheel screws.
• To ease alignment of the crankshaft and the flywheel,
bring the crank of one of the cylinders to TC (top
dead center). Make sure of the flywheel TC, align it
with the punch mark of the rear and plate, and set
the flywheel.
• Tighten the flywheel bolts to in diagonal order.
NOTE:
• Screw longer screws to the flywheel to carry it, if
needed.
B. BEARING CASE COVER
Loosen the screws first inside and next outside, and
lift the cover (1) by screwing two screws gradually and
evenly, referring to the photo.
(When reassembling)
• Apply grease to the oil seal lip and take care that it
is not rolled when installing.
(1) Bearing case cover
196W298A
196W299A
Tightening torque
12.7 ~ 15.7 Nm
1.3 ~ 1.6 kgf-m
9.8 ~ 11.2 lb-ft
Item
Flywheel screw
Tightening torque
54 ~ 59 Nm
5.5 ~ 6.0 kgf-m
40 ~ 43 lb-ft
Item
Bearing case cover screw
(1) Rear plate
T46W2D3B
NOTE:
• When installing the main bearing case cover, the
“UP” mark on it should be at the highest position so
that its holes are aligned with the holes of the cylin-
der block.
up
ENGINE - SERVICING