Daedong CK22 - Power Lift Assy Assembly, Dissembly and Installation; Cylinder Removal

10-39
DS35-W00 May. 2007
CLUTCHCLUTCH CLUTCHCLUTCH
CLUTCH
TRANSMISSIONTRANSMISSION TRANSMISSIONTRANSMISSION
TRANSMISSION
ENGINEENGINE ENGINEENGINE
ENGINE
HSTHST HSTHST
HST
FRONT AXLEFRONT AXLE FRONT AXLEFRONT AXLE
FRONT AXLE
STEERINGSTEERING STEERINGSTEERING
STEERING
BARKEBARKE BARKEBARKE
BARKE
ELECTRICELECTRIC ELECTRICELECTRIC
ELECTRIC
INDEXINDEX INDEXINDEX
INDEX
HYDRAULICHYDRAULIC HYDRAULICHYDRAULIC
HYDRAULIC
GENERALGENERAL GENERALGENERAL
GENERAL
REAR AXLEREAR AXLE REAR AXLEREAR AXLE
REAR AXLE
CK22/CK22H
4. Hold cylinder with large opening down and remove
piston from bore.
5. Inspect cylinder bore, piston and piston seal for
damage. Replace as necessary.
6. Replace O-ring and seal washer.
196W964A
(1) Piston (4) O-ring
(2) Piston Seal (5) Seal Washer
(3) Cylinder (6) Joint Bolt
4.5 POWER LIFT ASSY ASSEMBLY,
DISSEMBLY AND INSTALLATION
4.5.1 CYLINDER REMOVAL
1. Remove socket head cap screw (1) securing cylin-
der to body.
2. Support cylinder and remove cylinder joint bolt (2)
securing front of cylinder to body.
196W961A
196W962A
3. Carefully rotate cylinder (1) out of body and sepa-
rate cylinder (1) from plunger (2).
(1) Socket Head Cap Screw
(2) Joint Bolt
(1) Cylinder (2) Plunger
HYDRAULIC SYSTME - SERVICING