Daedong CK22 - Chapter 5. Hst; Specifications

5-2
DS35-W00 May. 2007
CLUTCHCLUTCH CLUTCHCLUTCH
CLUTCH
TRANSMISSIONTRANSMISSION TRANSMISSIONTRANSMISSION
TRANSMISSION
ENGINEENGINE ENGINEENGINE
ENGINE
HSTHST HSTHST
HST
FRONT AXLEFRONT AXLE FRONT AXLEFRONT AXLE
FRONT AXLE
STEERINGSTEERING STEERINGSTEERING
STEERING
BARKEBARKE BARKEBARKE
BARKE
ELECTRICELECTRIC ELECTRICELECTRIC
ELECTRIC
INDEXINDEX INDEXINDEX
INDEX
HYDRAULICHYDRAULIC HYDRAULICHYDRAULIC
HYDRAULIC
GENERALGENERAL GENERALGENERAL
GENERAL
REAR AXLEREAR AXLE REAR AXLEREAR AXLE
REAR AXLE
CK22/CK22H
Displacement
Angle of swash plate
Charge pump displacement
Maximum working pressure
(Relief setting pressure)
Continuous maximum pressure
Maximum input rpm
Theoretical output rpm
Maximum output torque
(theoretical)
Theoretical corner output
Charge relief pressure
Spiral bevel gear pinion turning torque
PTO shaft lock nut tightening torque
Backlash between
Spiral bevel gear turning torque
Adjusting shims thickness
Backlash between spiral bevel pinion gear
and spiral bevel gear
0 ~ 16.4 cc/rev
16.4 cc/rev
0 ~ 16
16°
4.1 cc/rev
280 kgf/cm
2
3982.5 psi
210 kgf/cm
2
3,200 rpm
0 ~ 3,200 rpm
63.7 Nm
6.5 kgf-m
47 lb-ft
29.1 ps
5 ~ 7 kgf/cm
2
71.1 ~ 99.5 psi
0.98 ~ 1.28 Nm
0.1 ~ 0.13 kgf-m
0.72 ~ 0.94 lb-ft
147.1 ~ 196.1 Nm
15 ~ 20 kgf-m
108.5 ~ 144.7 lb-ft
0.15 ~ 0.25 mm
0.0059 ~ 0.0098 in.
0.8, 1.0, 1.2 mm
0.0314, 0.0393, 0.045 in.
3.9 ~ 6.37 Nm
0.4 ~ 0.65 kgf-m
2.9 ~ 4.7 lb-ft
0.1, 0.2, 0.4 mm
0.0039, 0.0078, 0.0157 in.
0.15 ~ 0.25 mm
0.0059 ~ 0.0098 in.
Reference Value Allowable Limit
Item
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
HST
Pump Motor
Pump Motor
Differential pinion to
differential side gear
Differential washer
thickness
1. SPECIFICATIONS
HST - SPECIFICATIONS