5-22
DS35-W00 May. 2007
CLUTCHCLUTCH
CLUTCHCLUTCH
CLUTCH
TRANSMISSIONTRANSMISSION
TRANSMISSIONTRANSMISSION
TRANSMISSION
ENGINEENGINE
ENGINEENGINE
ENGINE
HSTHST
HSTHST
HST
FRONT AXLEFRONT AXLE
FRONT AXLEFRONT AXLE
FRONT AXLE
STEERINGSTEERING
STEERINGSTEERING
STEERING
BARKEBARKE
BARKEBARKE
BARKE
ELECTRICELECTRIC
ELECTRICELECTRIC
ELECTRIC
INDEXINDEX
INDEXINDEX
INDEX
HYDRAULICHYDRAULIC
HYDRAULICHYDRAULIC
HYDRAULIC
GENERALGENERAL
GENERALGENERAL
GENERAL
REAR AXLEREAR AXLE
REAR AXLEREAR AXLE
REAR AXLE
CK22/CK22H
9
10
11
14
12
13
17
15
16
4.4 HST PEDAL
(1) Rod
(2) Nut
(3) Lever
(4) Nut
(5) Adjust rod
(6) Joint
(7) Plate
(8) HST pedal
(9) Damper assembly
(10) Connector lever 2
(11) Lock arm
(12) Connector plate
(13) Lock shoe
(14) Lock shaft
(15) Connector
(16) Damper cylinder assembly
196W486A
1. Lift rod (1) to take up the free play adjust nuts until
distance (A) is 152 mm (5.984 in.).
Tighten the nuts.
2. Loosen nut (4) and adjust rod (5) until distance (B)
is 163.5 mm (6.437 in.).
Tighten the nut (4).
3. Start the tractor, engage the clutch and put the range
lever in the low or high position and the hydrostatic
lever in the neutral position. Disengage the clutch.
If the tractor moves, stop the tractor and adjust dis-
tance (B) again.
4. Put the joint (6) in the maximum forward travel posi-
tion and then return the lever to 0.5 ~ 1.0 mm (0.0196
~ 0.0393 in.) distance (C).
Adjust the plate (7) until there no clearance between
the pin on joint (6) and plate (7).
Item
Distance (A)
Distance (B)
Distance (C)
Factory Spec.
192 mm
7.559 in.
158 mm
6.22 in.
0.5 ~ 1.0 mm
0.019 ~ 0.039 in.
HST - SERVICING
To Next Page
Loading...
