Daedong CK22 - Disassembling and Assembling; Disassembling Brake Assembly

7-9
DS35-W00 May. 2007
CLUTCHCLUTCH CLUTCHCLUTCH
CLUTCH
TRANSMISSIONTRANSMISSION TRANSMISSIONTRANSMISSION
TRANSMISSION
ENGINEENGINE ENGINEENGINE
ENGINE
HSTHST HSTHST
HST
FRONT AXLEFRONT AXLE FRONT AXLEFRONT AXLE
FRONT AXLE
STEERINGSTEERING STEERINGSTEERING
STEERING
BARKEBARKE BARKEBARKE
BARKE
ELECTRICELECTRIC ELECTRICELECTRIC
ELECTRIC
INDEXINDEX INDEXINDEX
INDEX
HYDRAULICHYDRAULIC HYDRAULICHYDRAULIC
HYDRAULIC
GENERALGENERAL GENERALGENERAL
GENERAL
REAR AXLEREAR AXLE REAR AXLEREAR AXLE
REAR AXLE
CK22/CK22H
4.1.5 DISASSEMBLING AND ASSEMBLING
A. SEPARATING BRAKE ASSEMBLY
1. Remove the brake rod (1).
2. Remove the mounting bolts and remove the brake
assembly (2).
(When reassembling)
• When assembling, note left or right positions.
196W607A
Item
Brake assembly
mounting bolt
Tightening torque
24.5 ~ 29.4 Nm
2.5 ~ 3.0 kgf-m
18.1 ~ 21.7 lb-ft
4.1.6 DISASSEMBLING BRAKE ASSEMBLY
1. Remove the brake case cover mounting bolts (1),
case cover (13), Disc (3), brake plate (4), hub (12),
cam plate (5), and balls (6).
(1) Bolt (8) Cir-clip
(2) Spring washer (9) Brake lever
(3) Disc (10) O-ring
(4) Brake plate (11) O-ring
(5) Cam plate (12) Hub
(6) Ball (13) Case cover
(7) Brake case
a. It is possible to disassemble as shown in the fig-
ure right.
(When reassembling)
• Place the brake discs (3) so that the hole “A” of the
second disc should be overlapped 50 % or more.
• Apply grease to the O-ring (7) and take care not to
damage them.
196W613A
196W614A
(1) Brake rod (2) Brake assembly
BRAKE - SERVICING