Daedong CK22 - Fender; Front Wheel Driving Lever; Fuel Tank

4-26
DS35-W00 May. 2007
CLUTCHCLUTCH CLUTCHCLUTCH
CLUTCH
TRANSMISSIONTRANSMISSION TRANSMISSIONTRANSMISSION
TRANSMISSION
ENGINEENGINE ENGINEENGINE
ENGINE
HSTHST HSTHST
HST
FRONT AXLEFRONT AXLE FRONT AXLEFRONT AXLE
FRONT AXLE
STEERINGSTEERING STEERINGSTEERING
STEERING
BARKEBARKE BARKEBARKE
BARKE
ELECTRICELECTRIC ELECTRICELECTRIC
ELECTRIC
INDEXINDEX INDEXINDEX
INDEX
HYDRAULICHYDRAULIC HYDRAULICHYDRAULIC
HYDRAULIC
GENERALGENERAL GENERALGENERAL
GENERAL
REAR AXLEREAR AXLE REAR AXLEREAR AXLE
REAR AXLE
CK22/CK22H
196W436A
4.11 FUEL TANK
1. Drain the fuel tank.
2. Disconnect the fuel hose from the engine.
3. Disconnect the fender wire harness.
4. Remove the fuel filter (1).
5. Remove the nuts (2).
6. Remove the fuel tank assembly (3) & the socket
fixture.
4.12 FRONT WHEEL DRIVING LEVER
1. Remove the snap pin and plain washer and then
remove the lever rod (1).
2. Remove the snap ring and then remove the lever
(2).
(1) Fuel filter (2) Nuts (3) Tank assembly
196W435A
(1) Lever rod (2) Lever
4.10 FENDER
1. Rmove the connect of the rear combi lamp, turn sigal
lamp and working lamp.
2. Remove the ROPS mounting bracket (1).
3. Remove the grip (2) from the levers and then re-
move the lever guide (3).
4. Remove the fender (4).
5. Remove the fender support (5).
NOTE:
• For installation, follow the same procedure in re-
verse order.
196W434A
Item
Fender
support bolt
ROPS
support bolt
Tightening torque
77.5 ~ 90.1 Nm
7.9 ~ 9.2 kgf-m
57.2 ~ 66.5 lb-ft
124 ~ 147 Nm
12.6 ~ 15.0 kgf-m
91.2 ~ 108 lb-ft
Spec.
M12
M14
(1) Bracket (4) Fender
(2) Handle grip (5) Fender support
(3) Lever guide
TRANSMISSION - SERVICING