Daedong CK22 - Page 131

2-79
DS35-W00 May. 2007
CLUTCHCLUTCH CLUTCHCLUTCH
CLUTCH
TRANSMISSIONTRANSMISSION TRANSMISSIONTRANSMISSION
TRANSMISSION
ENGINEENGINE ENGINEENGINE
ENGINE
FRONT AXLEFRONT AXLE FRONT AXLEFRONT AXLE
FRONT AXLE
STEERINGSTEERING STEERINGSTEERING
STEERING
BARKEBARKE BARKEBARKE
BARKE
ELECTRICELECTRIC ELECTRICELECTRIC
ELECTRIC
INDEXINDEX INDEXINDEX
INDEX
HYDRAULICHYDRAULIC HYDRAULICHYDRAULIC
HYDRAULIC
GENERALGENERAL GENERALGENERAL
GENERAL
REAR AXLEREAR AXLE REAR AXLEREAR AXLE
REAR AXLE
HSTHST HSTHST
HST
CK22/CK22H
C. FUEL TIGHTNESS OF NEEDLE VALVE SEAT
TIGHTNESS
1. Set the injection nozzle to the nozzle tester.
2. Apply a pressure 130 kgf/cm² (12.75 MPa, 1,849 psi).
After keeping the nozzle under this pressure for 10
seconds. Check to see if fuel leaks from the nozzle.
3. If the should leak, replace the nozzle.
196W2H1A
D. INJECTION NOZZLE
Nozzle holder
1. Secure the nozzle retaining nut (7) with a vise.
2. Remove the nozzle holder (1) , and take out parts
inside.
(When reassembling)
• Assemble the nozzle in clean fuel oil.
• Install the push rod (4), noting its direction.
196W2H3A
(1) Nozzle holder (3) Nozzle spring
(2) Adjusting washer (4) Push rod
ENGINE - SERVICING