05/2014
6-185
DC SC2020
General
6.3.22 System_Data (FAX Service)
Version 1.1
825-016 External Telephone Call Time
(Time to Ring a sound from speaker if CNG is
not detected after incoming call)
21 0~255: 0s~255s
825-017 External Telephone Call Time during TEL/FAX
Switch Mode
O 6 0~255: 0s~255s
825-018 External Telephone Call Time during Answer-
ing Machine Connection Mode
O 21 0~255: 0s~255s
825-019 Call Time for FAX only O 0 0~255: 0s~255s
825-025 (14/0.5)Ring Signal Cycle Minimum Value Setting of detection possible cycle of Ring Signal
(1step=0.5ms)
28 8~255: 4ms~127.5ms
825-026 (100/0.5)Ring Signal Cycle Maximum Value Setting of detection possible cycle of Ring Signal
(1step=0.5ms)
200 8~255: 4ms~127.5ms
825-027 Dial Tone Frequency Dial Tone Detection possible frequency setting.
It is unused.
3 0: 350Hz~450Hz
1: 300Hz~500Hz
2: 450Hz~650Hz
3: 245Hz~650Hz
825-028 Busy Tone Frequency Busy Tone Detection possible frequency setting 3 0: 400Hz
1: 350Hz~450Hz
2: 300Hz~500Hz
3: 450Hz~650Hz
4: 245Hz~650Hz
825-029 Busy Tone Pattern Busy Tone Detection possible Pattern Setting 1 0: ON/OFF 0.4~0.6s (2 times)
1: ON/OFF 0.2~0.3s (4 times), ON/
OFF 0.4~0.6s (2 times)
2: ON/OFF 0.2~0.3s (4 times)
3: ON/OFF 0.12~0.44s (3 times)
4: ON/OFF 0.3~0.8s (2 times)
5: ON/OFF 0.2~0.6s (2 times)
6: ON/OFF 0.5~1s (2 times)
7: ON/OFF 0.12~1.2s (2 times)
8: ON 800~1.2S,OFF 3.2~4.8s (2
times)
825-030 Allow/Prohibit Busy Tone Detection during out-
going call
Busy Tone Detection Setting 1 0: Prohibit
1: Allowed
825-031 No. of Resend Making the outgoing call again for no. of this system data shall
be decided by the following requirements.
[When Busy Tone Detection[Prohibited]]
· Error occurred during FAX communication
[When Busy Tone Detection[Allowed]]
· Error occurred during FAX communication
· End when destination does not answer
O 1 0~5: 0time~5times
Table 1 6.3.22 System_Data (FAX Service)
Chain-Link NVM Name Detailed Description OFF/ON Default Value Setting Range
To Next Page
Loading...
Need help?
General
