05/2014
6-214
DC SC2020
6.4.8.4 NVM Setting
Version 1.1
General
6. The current value of the Heat Roll STS is displayed in hexadecimal (16).
Figure 2 j0bs640149
7. Press the [<--] (Back) button to return to the [Printer Diag] screen.
Figure 3 j0bs64016
8. Exit the CE mode. (See "6.4.4 How to Exit the CE Mode".)
6.4.8.4 NVM Setting
NVM (EEPROM of IOT) can access control panel key operation.
Reserve the following features.
• Able to read/write the contents from/to the IOT NVM.
NOTE: NVM List of IOT can be found in 6.3.3 - 6.3.21.
6.4.8.4.1 Read/Write from/to NVM (Edit NVM)
Read/Write the contents from/to the IOT NVM.
CAUTION
"Read/Write NVM (Edit NVM)" is to change the device-specific settings and the inadvertent operation or
missing settings may be an unrecoverable failure.
Operation Procedure
1. Enter the CE Mode. (Refer to "6.4.2 How to Enter the CE Mode")
2. Make sure [Printer Diag] is selected, and then press [OK] button.
3. [Down arrow] "IOT Diag" button to select, and then press [OK] button.
Figure 1 j0bs64010
4. [Down arrow] "NVM Settings" button to select, and then press [OK] button.
To Next Page
Loading...
Need help?
General
