223
7.3 Exposure with AeroDR Portable UF Unit
Chapter 7
6
Press [ ].
• The exposure is completed, and the display re-
turns to the initial screen.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• When consolidating image adjustment, press [
] to
pause the examination and return to the initial screen.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
7
When exposure is nished, turn the Aero-
DR Portable UF Unit o.
• Turn off the power switch of the AeroDR Por-
table UF Unit and confirm that the power LED
(green/orange) is OFF.
• For shutdown operation of the AeroDR Portable
UF Unit, refer to the "AeroDR Portable UF Unit
Operation Manual".
HINT
•••••••••••••••••••••••••••••••••••••
• Image adjustment can be done on the portable de-
vice's [Image Proc] tab. However, if a more advanced
image adjustment is required, perform image adjust-
ment on the [Image Proc] tab or the viewer screen.
For details on the viewer screen, refer to "6.7 Func-
tions of the viewer screen".
• When moving the exposure location, turn off the
AeroDR Portable UF Unit. After moving the exposure
location, perform the procedure again from step 1.
• It is all right to keep power of this device and the DR
Detector on.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT
•••••••••••••••••••••••••••••••••••••
• When importing examination information from the
higher system and when exposure body part information
is not imported, select the exposure body part. When
pressing [Perform] on the body part selection screen, the
exposure screen is displayed.
• When you move the focus in the image display area on
the exposure resumption waiting screen to capture an im-
age of another body part, not the ready-to-expose screen
but the exposure resumption waiting screen is displayed.
• Refer to "7.3 Exposure with AeroDR Portable UF Unit"
for information on the X-ray detection levels that can
be set for exposures.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
4
Perform exposure.
• Congure the portable X-ray device settings and
check the exposure setting before making an
exposure.
Press the exposure switch
•
As soon as the exposed image is transferred,
the image is displayed in the image display area.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• When performing an exposure, stay away from the pa-
tient as far as possible before pressing the exposure
switch.
• When the "Ready" is displayed, immediately perform
exposure.
• Do not let the DR Detector vibrate or receive shock
until the exposed image is displayed.
• If image acquisition started without performing ex-
posure, this may result in incorrect detection due to
noise, etc. Perform reject (image deletion) and repeat
exposure.
• If image acquisition does not start after exposure, the
voltage may not be enough. Check the exposure con-
ditions and repeat exposure.
• When exposure is done while "Ready" is not dis-
played, have an interval of 1 minute or more before
repeating exposure.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
5
Adjust the image.
• After exposure, adjust the image as required.
To Next Page
Loading...
