Konica Minolta CS-7 - Page 225

225
7.3 Exposure with AeroDR Portable UF Unit
Chapter 7
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• To prevent incorrect operations, always press
[AeroSync] and check that "Ready" is displayed.
• Conditions for changing the detection level vary
depending on the X-ray device being used. If a survey
has been carried out when the system was installed,
follow the survey results.
• When the AeroDR power management level is set to
[3], [4] or [5], it may take some time until the exposure
becomes ready after you have pressed [Aero Sync]. In
this case, [Standby] button instead of [Cancel] button
is displayed in the message/button area.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT
•••••••••••••••••••••••••••••••••••••
• Refer to "7.3 Exposure with AeroDR Portable UF Unit"
for information on the X-ray detection levels that can
be set for exposures.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
5
Perform exposure.
• Congure the portable X-ray device settings and
check the exposure setting before making an
exposure.
Press the exposure switch
• As soon as the exposed image is transferred,
the image is displayed in the image display area.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• When performing an exposure, stay away from the patient
as far as possible before pressing the exposure switch.
• When the "Ready" is displayed, immediately perform
exposure.
• Do not let the DR Detector vibrate or receive shock
until the exposed image is displayed.
• If image acquisition started without performing exposure,
this may result in incorrect detection due to noise, etc.
Perform reject (image deletion) and repeat exposure.
• If image acquisition does not start after exposure, the
voltage may not be enough. Check the exposure con-
ditions and repeat exposure.
• When exposure is done while "Ready" is not dis-
played, have an interval of 1 minute or more before
repeating exposure.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
6
Adjust the image.
• After exposure, adjust the image as required.
7
Press [ ].
• The exposure is completed, and the display re-
turns to the initial screen.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• When consolidating image adjustment, press [ ] to
pause the examination and return to the initial screen.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
8
When exposure is nished, turn the Aero-
DR Portable UF Unit o󰀨.
• Turn off the power switch of the AeroDR Por-
table UF Unit and confirm that the power LED
(green/orange) is OFF
.
• For shutdown operation of the AeroDR Portable
UF Unit, refer to the "AeroDR Portable UF Unit
Operation Manual".
HINT
•••••••••••••••••••••••••••••••••••••
• Image adjustment can be done on the portable de-
vice's [Image Proc] tab. However, if a more advanced
image adjustment is required, perform image adjust-
ment on the [Image Proc] tab or the viewer screen.
For details on the viewer screen, refer to "6.7 Func-
tions of the viewer screen".
• When moving the exposure location, turn off the
AeroDR Portable UF Unit. After moving the exposure
location, perform the procedure again from step 1.
• It is all right to keep power of this device and the DR
Detector on.
•••••••••••••••••••••••••••••••••••••••••••••••••••••