Konica Minolta CS-7 - Page 237

237
7.4 Exposure with Unitless
Chapter 7
4
Perform exposure.
• Congure the portable X-ray device settings and
check the exposure setting before making an
exposure.
Press the exposure switch
• As soon as the exposed image is transferred,
the image is displayed in the image display area.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• When performing an exposure, stay away from the pa-
tient as far as possible before pressing the exposure
switch.
• When the "Ready" is displayed, immediately perform
exposure.
• Do not let the DR Detector vibrate or receive shock
until the exposed image is displayed.
• If image acquisition started without performing ex-
posure, this may result in incorrect detection due to
noise, etc. Perform reject (image deletion) and repeat
exposure.
• If image acquisition does not start after exposure, the
voltage may not be enough. Check the exposure con-
ditions and repeat exposure.
• When exposure is done while "Ready" is not dis-
played, have an interval of 1 minute or more before
repeating exposure.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
5
Adjust the image.
• After exposure, adjust the image as required.
6
Press [ ].
• The exposure is completed, and the display re-
turns to the initial screen.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• When consolidating image adjustment, press [ ] to
pause the examination and return to the initial screen.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT
•••••••••••••••••••••••••••••••••••••
• Image adjustment can be done on the portable de-
vice's [Image Proc] tab. However, if a more advanced
image adjustment is required, perform image adjust-
ment on the [Image Proc] tab or the viewer screen.
For details on the viewer screen, refer to "6.7 Func-
tions of the viewer screen".
• If you have to move to the imaging location, perform
the procedure again from step 1 after arriving to the
imaging location.
• It is all right to keep power of this device and the DR
Detector on.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
z
When the [AeroSync Button] is ON
1
After arriving to the imaging location, conrm
that the icon for the DR Detector used for im-
aging appears in the application bar.
2
Select the examination.
3
Press [Perform].