MacDon FFT FlexDraper FD75 - Setting the Sensitivity of the Auto Header Height Control (John Deere 70 Series); Adjusting the Manual Header Raise;Lower Rate (John Deere 70 Series)

OPERATION
Setting the Sensitivity of the Auto Header Height Control (John Deere 7 0 Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
1. Press button
(A) twice and the current sensitivity
setting will
appear on the monitor (the lower the
reading, the
lower the sensitivity).
2. Use scroll kn
ob (B) to adjust the sensitivity setting. The
adjustment
will be saved automatically.
NOTE:
If the page remains idle for a short period of
time, it will automatically return to the previous
page. Pressing the check mark button (C) also
will return the monitor to the previous page.
Figure 3.194: Combine Control Console
NOTE:
The numbers depicted on the displays in these
illustrations are for r e fe rence purpose s only; they
are not in te nded to re present the specificsettings
for your equipment.
Figure 3.195: Combine Display
Adjusting the Manual Header Raise/Lower Rate (John Deere 70 Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
147695
1
42
Revision A