MacDon FFT FlexDraper FD75 - Detaching Header from Challenger, Gleaner, or Massey Ferguson Combine; Maintenance Specifications

HEADER ATTAC HMENT/D ETACH ME NT
14. Disengage both adapter float locks by movin g la tch (A)
away from adapter, and moving both header float lock
levers (B) down (UNLOCK).
15. Disengage both header flo at locks by pushing do w n
float lock handle (A) and placing it under the hook
(UNLOCK ).
Figure 4.
89: Float Lock in UN LOCK Position
4.6.2 Detaching Header from Challenger, Gleaner, o r
Massey Ferguson Combine
To detach a header from a Challenger, Gleaner, or Massey Ferguson combine, follow these steps:
DANGER
To avoid bodily
injury or death from unexpecte d start-up of machine, always stop engine an d remov e key
from ignition
before leaving operator’s seat for any reason.
1. Choose a level area. Position heade r slightly off the grou n d. Sto p eng in e and remove key.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
147695 236 Revision A