OPERATION
3.14 Storing Header
The following should be done at the end of each operating season:
CAUTION
Never use gasoline, naphtha, or any volatile material for cleaning purposes. These materials may be toxic
or flammable.
CAUTION
Cover cutterbar and knife guards to prevent injury from accidental contact.
1. Clean header tho
roughly.
2. Store machine i
n a dry, protected place if possible. If stored outside, always cover with a waterproof canvas or
other protecti
ve material.
NOTE:
If machine is stored outside, remove drapers and store in a dark, dry place. If drapers are not removed,
store header with cutterbar lowered so water/snow will not accumulate on d rapers. This accumulation of
weight puts excessive stress on drapers and header.
3. Lower header o
nto blocks to keep cutterbar off the ground.
4. Lower reel com
pletely. If stored outside, tie reel to frame to prevent rotation caused by wind.
5. Repain t all w
orn or chipped painted surfaces to prevent rust.
6. Loosen drive
belts.
7. Lubricate h
eader thoroughly, leaving excess grease on fittings to keep moisture out of bearings. Apply grease
to exposed t
hreads, cylinder rods, and sliding surfaces of components. Oil knife components to prevent rust.
8. Check fo r wo
rn or broken components, and repair or order replacements from your MacDon Dealer. Attention
to these ite
ms right away will save time and effort a t beginning of next season.
9. Replace or t
ighten any missing or loose hardware.
147695 196 Revision A
To Next Page
Loading...
