OPERATION
3.13.3 Conver
ting from Transport to F ield Position
To convert the header from Transport to Field position, follow these steps:
Removing Tow-Bar
Remove tow-bar as follows:
1. Block the tires to prevent header rolling, and unhook
from towing vehicle.
2. Disconnect wiring connector (A) on tow-bar.
3. Remove pin (B) from tow-bar and disassemble outer
section (C) from inner section (D).
Figure 3.269: Tow-Bar Assembly
4. Disconnect wiring connector (A) at front wheel.
Figure 3.270: Wiring Connector
147695 181 Revision A
To Next Page
Loading...
