OPERATION
Adjusting the Header Height (Challenger 6 Series)
Once the Auto Header Height Control (AHHC) is activated, press and release the header lower button on the
control handle. The AHHC will automatically lower the header to the selected height setting.
NOTE:
Changes may h
ave been made to the combine controls or display since this document was published. Refer to
the combine o
perator’s manual for updates.
The selected AHHC height is adjusted using the height
adjustment knob on the control console. Turning the knob
clockwise incre ases the s elected height, and turning the
knob counterclockwise decreases the selected height.
Figure 3.112: Height Adjustment Knob on the
Combine Control Console
Adjusting the Header Raise/Lower Rate (Challenger 6 Series)
NOTE:
Change
s m ay have been mad e to the combine controls or display since this document was published. Refer to
the com
bine operator’s manual for updates.
1. Press the Header icon on the FIELD page. The
HEADER page displays.
Figure 3.113: Challenger Combine Display
147695 99 Revision A
To Next Page
Loading...
