MAINTENANCE AND SERVICING
Greasing Procedure
Greasing points are marked on the machine by decals showing a grease gun and grease interval in hours of
operation. Master grease point location decals as shown below are provided on the header and adapter back frame.
Use the recommended lubricants specified in this manual.
Refer to 5.2.1 Recommended Fluids and Lubricants, page
252.
DANGER
To avoid bodily injury or death from unexpected
start-up of machine, always stop engine and remove
key from ignition before leaving operator ’s seat for
any reason.
Figure 5.1
4: FD75 Greasing Decal
1. Wipe grease fitting with a clean cloth before greasing
to avoid injecting dirt and grit.
2. Inject grease through fitting with grease gun until
grease overflows fitting (except where noted).
3. Leave excess grease on fittingtokeepoutdirt.
4. Replace any loose or broken fittings immediately.
5. Remove and thoroughly clean any fitting that will
not take grease. Also clean lubricant passageway.
Replace fitting if necessary.
6. Use clean High Temperature Extreme Pressure grease
as shown.
Figure
5.15: CA25 Adapter Greasing Decal
147695 268 Revision A
To Next Page
Loading...
