OPERATION
4. At the right end of the header, place the inner end
of the inner half of the tow-bar in cradle (A) on
header backtube.
5. Secure tube end in support (B) with clevis pin (C).
Secure with hairpin.
6. Install rubber strap (D) on cradle (A).
Figure 3.
273: Tow-Bar Storage
7. Attach header to combine. Refer to 4 H eader
Attachment/Detachment, page 197.
8. Place transport wheels into field position. Refer to:
• M oving F ront (Left) W
heels into Field Position, page
183
• Moving Rear (Right) W
heels into Field Position,
page 185
Moving Fro nt (Left) Wheels into Field Position
To move the front (left) tra
nsport wheels into field position, follow these steps:
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Raise header fully. Engage header safety props.
147695 183 Revision A
To Next Page
Loading...
