MAINTENANCE AND SERVICING
5.6.3 Removin
g Driveline Guard
The main driveline guard normally remains attached to the driveline, but can be removed for maintenance.
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator ’s seat for any reason.
NOTE:
The driveline does NOT need to be removed from the adapter in order to remove the driveline guard.
To remove a main driveline guard, follow these steps:
1. Rotate disc (B) on adapter driveline storage hook (A),
and remove driveline from hook.
Figure 5.37: Driveline
2. Lift combine end of driveline (A) from hook, and
extend driveline until it separates. Hold adapter end
of driveline to prevent it from dropping and hitting
the ground.
Figure 5.38: Guard
147695 280 Revision A
To Next Page
Loading...
