HEADER ATTA CHMEN T/DETACHMENT
10. Position coupler (A) onto combine receptacle, and pull
handle (B) to fully engage coupler into receptacle.
11. Connect reel fore-aft/header tilt selector harness (C) to
combine h arness (D).
Figure 4.86: Coupler
12. Rotate disc (A) on adapter driveline storage hook, and
remove driveline from hook.
Figure 4.87: Driveline
13. Pull back collar (A) on end of driveline, and push onto
combine output shaft (B) until collar locks.
Figure 4.88: Driveline
147695 235 Revision A
To Next Page
Loading...
