SAFETY
MD #184372
General hazard pertaining to machine operation
and servicing
CAUTION
To avoid injury or death from improper or unsafe
machine operation:
• Read the operator’s manual and follow all safety
instructions. If you do not have a manual, obtain one
from your Dealer.
• Do not allow untrained persons to operate the machine.
• Review safety instructions with all Operators annually.
• Ensure that all safety signs are installed and legible.
• Make certain everyo ne is clea r of machin e before
starting engine and during operation.
• Keep riders off the machine.
• K eep all shie ld s in place and stay clear of m oving parts.
• Disengage header drive, put transmission in Neutral,
and wait for all movement to stop before leaving
operator’s position.
• Shut off the engine and remove the key from ignition
before servicing, adjusting, lubricating, cleaning, or
unplugging machine.
• Engage safety props to prevent lowering of raised unit
before servicing in the raised position.
• Use slow moving vehicle emblem and flashing warning
lights when operating on roadways unless prohibited
by law.
Figure 1.32: MD #184372
MD #184422
Keep shields
in place hazard
WARNING
• Do not place
hand.
• To avoid in j
ury, stop the engine and remove the key
before open
ing power drive system shield.
•Keepallshi
elds in place.
Figure 1.33: MD #184422
147695 16 Revision A
To Next Page
Loading...
