Motorola RFS Series

Motorola RF Switch CLI Reference Guide
2-56
Usage Guidelines
1. The interface and VLAN status is displayed as UP regardless of a disconnection. In
such a case, shutdown the VLAN.
a. Check the status of an interface and VLAN using:
RFSwitch(config)#show ip interface brief
Interface IP-Address Status Protocol
vlan1 157.235.208.69(DHCP) up up
vlan3 unassigned up up
RFSwitch(config)#
If the status of the VLAN is UP, shutdown the VLAN associated with eth1 using:
RFSwitch(config-if)#show ip interface vlan 3 brief
Interface IP-Address Status Protocol
vlan3 unassigned up up
RFSwitch(config-if)#shutdown
b. Check the status. Note that the VLAN has now been disassociated and the status
is DOWN.
RFSwitch(config)#show ip interface brief
Interface IP-Address Status Protocol
vlan1 157.235.208.69(DHCP) up up
vlan3 unassigned administratively down down
RFSwitch(config)#
2. The above example could also occur when a DHCP interface is disconnected. DHCP is
not effected though, because it runs on a virtual interface and not on a physical
route [<IP>|<IP/Mask>
|detail]
Display IP routing table entries
•<IP> – Network in the IP routing table
• <IP/Mask> – Number of valid bits in the network prefix
IP prefix <network>/<length>, e.g., 35.0.0.0/8
• detail – Displays the IP routing table in detail
routing IP routing status
ssh Secured Shell (SSH) server
telnet Telnet server