xxv
| The pipe symbol. This is used to separate the variables/keywords
in a list.
For example, the command
RFSwitch> show .....
is documented as
show [autoinstall|banner|ip|ldap|......]
where:
• set – The command
• [autoinstall|banner|ip|ldap|......] – Indicates the different commands
that can be combined with the show command. However, only one of
the above list can be used at a time.
show autoinstall ...
show banner ...
show ip ...
show ldap ...
[ ] Of the different keywords and variables listed inside a ‘[‘ & ‘]’
pair, only one can be used. Each choice in the list is separated
with a ‘|’ (pipe) symbol.
For example, the command
RFSwitch# clear ...
is documented as
clear [crypto|mobility|spanning-tree]
where:
• clear – The command
• [crypto|mobility|spanning-tree] – Indicates that three keywords are
available for this command and only one can be used at a time
To Next Page
Loading...
