Motorola RFS Series

Global Configuration Commands
5-47
radius[accounting|
authentication-
protocol|dscp|
dynamic-authorization
|server]
Modifies Radius-related parameters
• accounting [mode|server|timeout] – Describes the
Radius accounting parameters
• mode start-interim-stop interval <60-3600> –
Specifies the accounting mode on this VLAN
• start-interim-stop interval <60-3600> – Sends
Accounting Start-Interim-Stop
• interval <60-3600> – The Interim Interval
between successive accounting updates
• start-stop – Sends Accounting Start-Stop
• stop-only – Sends Accounting Stop only
• server [primary|secondary] – Modifies the Radius
server parameters
• primary – Modifies the Radius server parameters
on the Primary server.
• secondary – Modifies the Radius server
parameters on the Secondary server.
The following parameters are common for both primary and
secondary servers.
• <A.B.C.D>{acct-port} <1024-65535> – Specifies
the Radius server IP address and accounting port
values
• radius-key [0 <LINE>|2 <LINE>|LINE] – Specifies
the Radius server shared secret, upto 127
characters
• timeout <1-300> retransmit <1-100> – Time the
wireless switch waits for a response from the Radius
server before retrying Accounting
• <1-300> retransmit<1-100> – Timeout in seconds
• retransmit<1-100> – Number of retries before
the wireless switch gives up Accounting
• authentication-protocol [CHAP|PAP] – Describes the
authentication protocols used in the Radius server
requests.