Global Configuration Commands
5-63
• ip nat [inside|outside] source static <outside-global-IP>
<local-IP> – Sets the parameters for translation for inside
sources
• inside – Indicates inside address translation
• outside – Indicates outside address translation
• source – Indicates source address translation
• static – Specifies local -> global address mapping
• <outside-global-IP> – The static global IP address to
map from
• <local-IP> – The local IP address to map to
route [<IP-destination-
prefix> <IP-destination-
prefix-mask>|<IP-
destination-prefix/
Mask>] <gateway-IP>
Adds a static route entry in the routing table.
• <IP-destination-prefix>– IP destination prefix
• <IP-destination-prefix-mask> – Mask for the
<IP-destination-prefix> IP
• <IP-destination-prefix/Mask> – IP destination prefix
with mask
• <gateway-IP> – IP address of the next hop used to
reach the destination
routing Turns on IP routing
ssh {[port <port>|rsa
keypair-name <key-pair-
name>]}
Sets up the Secured Shell (SSH) server
•
port <port> –
Optional. Defines the
listening port (set
between 0-65536)
• rsa keypair-name <key-pair-name> – Optional. Sets the
RSA encryption key used for configuring RSA keypair
telnet {port <port>} Configures the Telnet server.
•
port <port> –
Optional. Defines the
listening port ID
(set between 0-65535)
To Next Page
Loading...
Need help?
General
