Global Configuration Commands
5-133
ip access-list standard stdacl3
deny host 30.0.0.14 rule-precedence 54
no access-list stdacl
wlan-acl 5 stdacl1 in
wlan-acl 6 stdacl2 in
The stdacl must be detached from the interface to which it was associated and stdacl3
must be attached to that interface.
When the user explicitly creates ACL rules with WLAN index as selector, the switch
consumes that ACL without WLAN index selector. During this process a warning is raised
to the user as mentioned in the example below.
RFSwitch(config)#access-list 14 permit any wlan 19 log
Warning : Acl rules with Wlan Index is deprecated. Wlan
index configured for the rule will be ignored. Please use
wlan-acl CLI to apply ACLs on WLAN
Example
The example below applies an ACL to WLAN index 200 in an inbound direction from the
global config mode.
RFSwitch(config)#wlan-acl 2 150 in
RFSwitch(config)#
The example below applies an ACL to WLAN index 200 in outbound direction from the
global config mode.
RFSwitch(config)#wlan-acl 2 150 out
RFSwitch(config)#
NOTE: A MAC access list entry to allow arp is mandatory to apply an
IP based ACL to an interface. MAC ACL always takes precedence over
IP based ACL’s.
To Next Page
Loading...
Need help?
General
