Wireless Instance
Use the (config-wireless) instance to configure local RADIUS server parameters
associated with the switch.
To navigate to this instance, use the command from the Global Config mode.
RFSwitch(config)#wireless
RFSwitch(config-wireless)#
20.1 Wireless Configuration Commands
This table summarizes (config-wireless) commands:
Command Description Ref.
aap Sets Adaptive AP (AAP) related commands page 20-6
admission-control Enable admission control across all radios page 20-9
adopt-unconf-radio Adopts a radio even if its not yet configured.
The default templates can be used for
configuration.
page 20-10
adoption-pref-id Used as a preference identifier for this switch.
All radios configured with this preference
identifier are more likely to be adopted by this
switch.
page 20-11
ap Displays access port related commands page 20-12
To Next Page
Loading...
