Motorola RFS Series

Motorola RF Switch CLI Reference Guide
20-76
amsdu [rx-limit|
tx-enable]
Specifies the settings for the MAC Service frames. The
following properties are configured:
• rx-limit – The receive buffer limit in bytes
• tx-enable – Optional parameters for enabling
transmitting A-MSDUs
• <3839 bytes>|<7935 bytes> – The number of bytes
received
Note: Before executing this command, ensure the radio is
present and is a AP650 model.
antenna-mode
[1x1-
mimo|diversity|mimo
|mimo-diversity|
|primary|secondary]
Defines the antenna diversity mode. Select from the
following options:
• 1x1-mimo – Uses only antenna A to transmit and receive
• diversity – Full diversity (both antennas)
•mimo – MIMO
• mimo-diversity – For non-11n transmit rates
• primary – Primary antenna only
• secondary – Secondary antenna only
Note: Before executing this command, ensure the radio is
present and is a AP300/AP650 model.
base-bridge [enable|
max-clients <1-12>]
Sets base bridge values
• enable – Allows the given radio to act as a base bridge
and accept connections from client bridges
• max-clients <1-12> – Configures a base-bridge. Enter
maximum client bridges allowed
beacon-interval
<50-200>
Sets the beacon interval (in K-uSec)
bridge-fwd-delay <4-30> Sets the STP bridge forward delay (in seconds)
• <4-30> - Time in seconds
bridge-hello <1-10> Sets the STP bridge hello (in seconds)
• <1-10> - Time in seconds