Motorola RF Switch CLI Reference Guide
21-8
Use [no] enable and [no] engine <ip><port> to undo theekahau RTLS engine
configuration and disable it.
Example
RFS7000(config-rtls)#ekahau enable
RFS7000(config-rtls)#
RFS7000(config-rtls)#ekahau engine ip 10.1.1.1 port 1001
RFS7000(config-rtls)#
RFS7000(config-rtls)#ekahau multicast-listen-addr 01-18-8E-
00-00-00
RFS7000(config-rtls)#
21.1.9 no
RTLS Config Commands
Negates a RTLS command or set its defaults
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
no [aeroscout|ekahau|reference-tag|service|site|
switch|ap|zone]
Parameters
engine ip<IP>
port <Port>
Configures the IP address and port number of the external
ekahau RTLS engine
• ip – Configures external location engine IP address
• port <1000-9000> – Configure external location engine
port
multicast-
listen-addr
<MAC>
Configures multicast MAC address to which ekahau tags
packets are destined
• <MAC> – Multicast MAC address
To Next Page
Loading...
