Motorola RFS Series

Motorola RF Switch CLI Reference Guide
25-16
radio all-11bg coverage-rate
[1|2|5p5|6|9|11|12|18|24|36|48|54]
radio all-11bg lock-auto-assign
[all|channel|detector|power|rescuer]
Parameters
<1-4096> [antenna-gain |
coverage-rate |
lock-auto-assign |
radio-mac | rescuer]
Sets the following parameters for the selected radio:
• antenna-gain <GAIN> – Sets the antenna-gain value to
GAIN for the selected radio
• coverage-rate [1|2|5p5|6|9|11|12|18|24|36|48|54] – Sets
the coverage rate threshold value for under-coverage
detection to the selected value from the list
• lock-auto-assign [all|channel|detector|power|rescuer] –
Locks rf configuration from automatic smart rf
assignments
• radio-mac <AA-BB-CC-DD-EE-FF> – Sets the radio MAC
address for the radio with the selected index
• rescuer {AA-BB-CC-DD-EE-FF <4-20> <0-65535> } – Sets
the MAC address for the rescuer radio. The following
parameters are also set:
• <4-20> – Boost power to cover for the defective radio.
• <0-65535> – Attenuation from the rescuer radio to
the selected radio. This is for information purposes
only
• width [auto|dual|single] – Configures channel-width
preference during calibration
• auto – Auto channel-width - lets smart-rf figure out
the best channel-width
• dual – Dual channel-width - 40 MHz
• single – Single channel-width - 20MHz