Rohde & Schwarz SMBV100B - Page 654

Remote Control Commands
R&S
®
SMBV100B
652User Manual 1178.4460.02 ─ 03
:SENSe<ch>[:POWer]:CORRection:SPDevice:STATe........................................................655
:SENSe<ch>[:POWer]:CORRection:SPDevice:LIST?.........................................................656
:SENSe<ch>[:POWer]:DISPlay:PERManent:PRIority.........................................................656
:SENSe<ch>[:POWer]:DISPlay:PERManent:STATe........................................................... 656
:SENSe<ch>[:POWer]:FILTer:LENGth:AUTO?.................................................................. 656
:SENSe<ch>[:POWer]:FILTer:LENGth[:USER].................................................................. 657
:SENSe<ch>[:POWer]:FILTer:NSRatio............................................................................. 657
:SENSe<ch>[:POWer]:FILTer:NSRatio:MTIMe.................................................................. 658
:SENSe<ch>[:POWer]:FILTer:SONCe.............................................................................. 658
:SENSe<ch>[:POWer]:FILTer:TYPE................................................................................. 658
:SENSe<ch>[:POWer]:FREQuency..................................................................................659
:SENSe<ch>[:POWer]:LOGGing:STATe............................................................................659
:SENSe<ch>[:POWer]:OFFSet........................................................................................660
:SENSe<ch>[:POWer]:OFFSet:STATe..............................................................................660
:SENSe<ch>[:POWer]:SNUMber?................................................................................... 660
:SENSe<ch>[:POWer]:SOURce.......................................................................................660
:SENSe<ch>[:POWer]:STATus[:DEVice]?.........................................................................661
:SENSe<ch>[:POWer]:SVERsion?...................................................................................661
:SENSe<ch>[:POWer]:TYPE?.........................................................................................661
:SENSe<ch>[:POWer]:ZERO.......................................................................................... 662
:SLISt[:LIST]?
Returns a list of all detected sensors in a comma-separated string.
Return values:
<SensorList> String of comma-separated entries
Each entry contains information on the sensor type, serial num-
ber and interface.
The order of the entries does not correspond to the order the
sensors are displayed in the "NRP Sensor Mapping" dialog.
Example: See Example "Detecting and assigning a power sensor"
on page 650.
Usage: Query only
Manual operation: See " Sensor Mapping List " on page 395
:SLISt:SCAN[:STATe] <State>
Starts the search for R&S NRP power sensors, connected in the LAN or via the
USBTMC protocol.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Detecting and assigning a power sensor"
on page 650.
Manual operation: See " Scan " on page 395
SENSe, READ, INITiate and SLISt Subsystems