Rohde & Schwarz SMBV100B - Page 688

Remote Control Commands
R&S
®
SMBV100B
686User Manual 1178.4460.02 ─ 03
Usage: Query only
Options: R&S SMBVB-B9
Manual operation: See "Aggregated Link Sample Rate" on page 461
[:SOURce<hw>]:BBIN:MODE <Mode>
Defines that a digital external signal is applied.
Parameters:
<Mode> DIGital
*RST: DIGital
Example: See Example "Applying an external digital baseband signal (HS
Dig I/Q)" on page 682.
[:SOURce<hw>]:BBIN:SRATe:SOURce
<Source>
Sets the digital interface used to estimate the sample rate.
Parameters:
<Source> DIN | HSDin
DIN
Estimates the sample rate based on the digital input signal.
HSDin
Enabled for [:SOURce<hw>]:BBIN:DIGital:INTerface
HSDin
*RST: HSDin
Example: See Example "Applying an external digital baseband signal (HS
Dig I/Q)" on page 682.
Manual operation: See "Sample Rate Source" on page 458
[:SOURce<hw>]:BBIN:SRATe[:ACTual]?
Queries the sample rate of the external digital baseband signal.
Return values:
<Actual> float
Example: See Example "Applying an external digital baseband signal (HS
Dig I/Q)" on page 682.
Usage: Query only
Manual operation: See "Sample Rate Value" on page 463
[:SOURce<hw>]:BBIN:DIGital:ASETting:STATe <State>
Activates automatic adjustment of the baseband input signal.
SOURce Subsystem