Rohde & Schwarz SMBV100B - Page 764

Remote Control Commands
R&S
®
SMBV100B
762User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STATe..........................................769
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STARt..........................................770
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STOP.......................................... 770
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer:STEP............................... 770
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer[:STARt].............................770
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:PHASe:STEP............................... 771
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:PHASe[:STARt].............................771
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:DELay:STEP................................ 771
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:DELay[:STARt]..............................772
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:FILE............................................ 772
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:EXECute......................................772
[:SOURce<hw>]:BB:ARBitrary:MCARrier:PRESet
Sets all the multi-carrier parameters to their default values.
Example:
SOURce1:BB:ARBitrary:MCARrier:PRESet
Usage: Event
Manual operation: See "Set to Default" on page 227
[:SOURce<hw>]:BB:ARBitrary:MCARrier:SETTing:CATalog?
Queries the available settings files in the specified default directory. Only files with the
file extension *.arb_multcarr are listed.
Return values:
<Catalog> string
Example: See Example "Generating a multi carrier signal" on page 744
Usage: Query only
Manual operation: See "Save/Recall Frame" on page 228
[:SOURce<hw>]:BB:ARBitrary:MCARrier:SETTing:LOAD <Filename>
Loads the selected file from the default or the specified directory. Loaded are files with
extension *.arb_multcarr.
Setting parameters:
<Filename> "<filename>"
Filename or complete file path; file extension can be omitted
Example: See Example "Generating a multi carrier signal" on page 744.
Usage: Setting only
Manual operation: See "Save/Recall Frame" on page 228
SOURce Subsystem