Remote Control Commands
R&S
®
SMBV100B
899User Manual 1178.4460.02 ─ 03
:SYSTem:COMMunicate:NETWork:IPADdress <IpAddress>
Sets the IP address.
Parameters:
<IpAddress> string
Range: 0.0.0.0. to ff.ff.ff.ff
Example: See Example "Retrieving information on network-related set-
tings" on page 889.
Manual operation: See "IP Address" on page 564
:SYSTem:COMMunicate:NETWork:IPADdress:MODE <Mode>
Selects manual or automatic setting of the IP address.
Parameters:
<Mode> AUTO | STATic
*RST: n.a. (factory preset: AUTO)
Example: See Example "Retrieving information on network-related set-
tings" on page 889.
Example:
SYSTem:COMMunicate:NETWork:IPADdress:MODE
STATic
SYSTem:COMMunicate:NETWork:IPADdress
"10.113.0.105"
Manual operation: See "Address Mode" on page 563
:SYSTem:COMMunicate:NETWork:MACaddress <MacAddress>
Queries the MAC address of the network adapter.
This is a password-protected function. Unlock the protection level 1 to access it, see :
SYSTem:PROTect<ch>[:STATe].
Parameters:
<MacAddress> string
Example: See Example "Retrieving information on network-related set-
tings" on page 889.
Manual operation: See "MAC Address" on page 565
:SYSTem:COMMunicate:NETWork:RESource?
Queries the visa resource string for Ethernet instruments.
Return values:
<Resource> string
SYSTem Subsystem
To Next Page
Loading...
