Operate the motor in the factory setting
We recommend that you execute quick commissioning. For quick commissioning, you must
adapt the converter to the connected motor by setting the motor data in the converter.
For basic applications, you can try to operate the drive with a rated power < 18.5 kW without any
other commissioning steps. Check whether the control quality of the drive without
commissioning is adequate for the requirements of the application.
Commissioning
5.3 Preparing for commissioning
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB 109
To Next Page
Loading...
