Siemens SINAMICS G120XA - Safely Remove the Memory Card

(6&2.
;;;<<<
&/21,1*
Start data transfer with OK.
)520&5'
G2Q(
Wait until the converter has transferred the settings from the memory card.
Switch off the converter power supply.
Wait until all LEDs on the converter are dark.
Switch on the converter power supply again.
You have transferred the settings from the memory card to the converter.
❒
8.1.4 Safely remove the memory card
NOTICE
Data loss from improper handling of the memory card
If you remove the memory card when the converter is switched on without implementing the
"safe removal" function you may destroy the file system on the memory card. The data on the
memory card are lost. The memory card will only function again after formatting.
● Only remove the memory card using the "safe removal" function.
Function description
Procedure with the BOP-2
3$5$06
67$1'$5'
),/7(5
3
ැ
1. Set p9400 = 2.
If a memory card is inserted, p9400 = 1.
3

3

2. The converter sets p9400 = 3 or p9400 = 100.
● p9400 = 3: You may remove the memory card from the converter.
● p9400 = 100: You must not remove the memory card. Wait for several
seconds and then set p9400 = 2 again.
3

3. Remove the memory card. After removing the memory card, p9400 = 0.
You have now safely removed the memory card using BOP-2.
❒
Saving the settings and series commissioning
8.1 Memory card
SINAMICS G120XA converter
730 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB