Siemens SINAMICS G120XA - KHP Configuration; KHP Config; KHP Password Input; KHP Passw Input

Note
KHP: Know-How Protection
Even if know-how protection is set, parameters in this list can be read and written to.
p7765 KHP configuration / KHP config
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
0000 bin
Description: Configuration settings for know-how protection.
For bit 00, 01:
When KHP is activated, this means that the OEM can define whether the parameters and DCC data encrypted on the
memory card should be protected before using on other memory cards/Control Units.
For bit 02:
This means that the OEM can define whether it is possible or not to trace the drive data using the device trace function
although KHP is activated.
Bit field: Bit Signal name 1 signal 0 signal FP
00 Extended copy protection - linked to the memory card and CU Yes No -
01 Basic copy protection - linked to the memory card Yes No -
02 Permit trace and measuring functions for diagnostic
purposes
Yes No -
Dependency: See also: p7766, p7767, p7768
Note
KHP: Know-How Protection
For copy protection, the serial numbers of the memory card and/or Control Unit are checked.
The memory card copy protection and preventing data to be traced are only effective when the know-how protection
has been activated.
For bit 00, 01:
If both bits are inadvertently set to 1 (e.g. at the BOP-2), then the setting of bit 0 applies.
There is no copy protection if both bits are set to 0.
p7766[0...29] KHP password input / KHP passw input
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: Sets the password for know-how protection.
Example of a password:
123aBc = 49 50 51 97 66 99 dec (ASCII characters)
[0] = character 1 (e.g. 49 dec)
[1] = character 2 (e.g. 50 dec)
...
[5] = character 6 (e.g. 99 dec)
[29] = 0 dec (completes the entry)
Dependency: See also: p7767, p7768
Parameters
7.3 Parameters
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB 667