Siemens SINAMICS G120XA - Installing the Current Sensor

10.Remove the current sensor (TX-20).
7;
7;
11.Remove the holding plate (TX-20).
7;
7;
The current sensor is removed.
❒
Installing the current sensor
1. Mount the holding plate (TX-20).
2. Mount the current sensor (TX-20).
3. Mount the copper bar (TX-30).
4. Mount the copper bar (TX-30).
5. Plug the current sensor cables.
6. Mount the metal cover (TX-30).
7. Mount the metal cover (TX-20 and TX-30).
8. Mount the PE connect sheet metal (Hexagon 10 mm).
9. Connect the power cables (Hexagon 19 mm).
10.Mount the front cover.
11.Insert 2 screws (TX-25) of the front cover.
The current sensor is installed.
❒
Corrective maintenance
10.2 Replacing spare parts
SINAMICS G120XA converter
848 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB