Parameters
Table 9-6 Parameters of the fault buffer and the fault history
Parameter Description Factory setting
r0945[0 … 63] Fault code -
r0948[0 … 63] Fault time received in milliseconds - ms
r0949[0 … 63] Fault value -
p0952 Fault cases counter 0
r2109[0 … 63] Fault time removed in milliseconds - ms
r2130[0 … 63] Fault time received in days -
r2131 CO: Actual fault code -
r2133[0 … 63] Fault value for float values -
r2136[0 … 63] Fault time removed in days -
Extended settings for faults
Parameter Description Factory setting
p2100[0…19] Changing the fault reaction, fault number 0
p2101[0…19] Changing the fault reaction, reaction 0
p2118[0 … 19] Change message type, message number 0
p2119[0 … 19] Change message type, type 1
p2126[0 … 19] Changing the acknowledge mode, fault number 0
p2127[0 … 19] Changing the acknowledge mode 1
Further information is provided in the parameter list.
Warnings, faults and system messages
9.5 Faults, alarm buffer and alarm history
SINAMICS G120XA converter
752 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB
To Next Page
Loading...
