Siemens SINAMICS G120XA - Basic Setup of Motorized Potentiometer; Extended Setup of Motorized Potentiometer

Parameters
Table 6-43 Basic setup of motorized potentiometer
Number Name Factory setting
p1035[C] BI: Motorized potentiometer setpoint higher 0
p1036[C] BI: Motorized potentiometer setpoint lower Dependent on the
converter
p1040[D] Motorized potentiometer start value 0 rpm
p1047[D] Motorized potentiometer, ramp-up time 10 s
p1048[D] Motorized potentiometer, ramp-down time 10 s
r1050 Motorized potentiometer, setpoint after the ramp-function
generator
- rpm
p1070[C] CI: Main setpoint Dependent on the
converter
p1071[C] CI: Main setpoint scaling 1
r1073 CO: Main setpoint active - rpm
p1075[C] CI: Supplementary setpoint 0
p1076[C] CI: Supplementary setpoint scaling 1
Table 6-44 Extended setup of motorized potentiometer
Number Name Factory setting
p1030[D] Motorized potentiometer configuration 0000 0110 bin
p1037[D] Motorized potentiometer, maximum speed 0 rpm
p1038[D] Motorized potentiometer, minimum speed 0 rpm
p1043[C] BI: Motorized potentiometer, accept setting value 0
p1044[C] CI: Motorized potentiometer, setting value 0
Advanced commissioning
6.4 Setpoints and setpoint processing
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB 229