Siemens SINAMICS G120XA - Setting the Address

6.2.5.3 Setting the address
Function description
Procedure
1. Using parameter p2021, set the address using an operator panel or SINAMICS G120 Smart
Access.
Permissible addresses: 0 … 127.
2. Switch off the converter power supply.
3. Wait until all LEDs on the converter are dark.
4. Switch on the converter power supply again.
Your settings become active after switching on.
You have set the bus address.
❒
Parameters
Parameter Description Factory setting
p2021 Fieldbus interface address 0
Advanced commissioning
6.2 Drive control
SINAMICS G120XA converter
182 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB