3. Remove the connectors on the power supply board.
4. Remove 5 screws (TX-20).
7;
7;
1P
7;
7;
7;
5. Remove the power supply board.
The power supply board is removed.
❒
Installing the power supply board
1. Align the power supply board to the screw holes.
2. Insert 5 screws (TX-20)
Tightening torque: 1.8 Nm.
3. Plug the connectors onto the power supply board.
4. Install the front cover.
5. Insert 2 screws (TX-25) of the front cover.
Tightneing torque: 3 Nm.
The power supply board is installed.
❒
Corrective maintenance
10.2 Replacing spare parts
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB 841
To Next Page
Loading...
