Siemens SINAMICS G120XA - U;F Control with Standard Drive Control; Default Setting of U;F Control after Selecting Standard Drive Control; Characteristics after Selecting Standard Drive Control

6.6.2.3 U/f control with Standard Drive Control
Overview
8IFKDUDFWHUL
VWLF
6OLSFRPSHQVD
WLRQ
9ROWDJHERRVW
QൺI
6SHHGVHWSRLQW
I
VHW
,
TBVHW
8
VHW
2XWSXWYROWDJH
2XWSXWIUHTXHQF\
&XUUHQWVHWSRLQW,
TBVHW
U
U
U
U
0
Q


8
I
Figure 6-61 Default setting of the U/f control after selecting Standard Drive Control
Selecting application class Standard Drive Control in the quick commissioning adapts the
structure and the setting options of the U/f control as follows:
● Starting current closed-loop control: At low speeds, a controlled motor current reduces the
tendency of the motor to oscillate.
● With increasing speed, the converter changes from closed-loop starting current control to U/
f control with load-dependent voltage boost.
● The slip compensation is activated.
● Soft starting is not possible.
● Reduced setting options
Function description
Characteristics after selecting the application class Standard Drive Control
I
VHW
8
VHW
I
VHW
,
TBVHW
,
TBVHW
0D[LPXPRXWSXW
YROWDJH
7HFKQRORJLFDODSSOLFDWLRQ
5DWHGPRWRUIUHTXHQF\
/LQHDU
3DUDEROLF


S
S
S
U
U




① The closed-loop starting current control optimizes the speed control at low speeds
② The converter compensates the voltage drop across the motor stator resistance
Figure 6-62 Characteristics after selecting Standard Drive Control
Advanced commissioning
6.6 Motor control
SINAMICS G120XA converter
284 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB