Siemens SINAMICS G120XA - Code Numbers of the Object Types Supported in Bacnet; Object Properties of the Device Object Type; Object Properties of Other Object Types

Note
SubscribeCOV services are not retentive; i.e., when restarting the CU the master must
reinitiate SubscribeCOV services.
Code numbers of the object types supported in BACnet
Object type Code number for BACnet
object type
Object type Code number for BACnet ob‐
ject type
Device Object 8 Analog Output Object 1
Binary Input Object 3 Analog Value Object 2
Binary Output Object 4 Multi-State Input Object 13
Binary Value Object 5 Octet String Values 47
Analog Input Object 0
Object properties of the "Device" object type
● Object_Identifier ● Application_Software_Version ● APDU_Timeout
● Object_Name ● Protocol_Version ● Number_Of_APDU_Retries
● Object_Type ● Protocol_Revision ● Max Master
● System_Status ● Protocol_Services_Supported ● Max Info Frames
● Vendor_Name ● Protocol_Object_Types_Supported ● Device Address Binding
● Vendor_Identifier ● Object_List ● Database Revision
● Model_Name ● Max_APDU_Length_Accepted
1)
● Firmware_Revision ● Segmentation_Supported
2)
1)
Length = 480,
2)
not supported
Object properties of other object types
Object
property
Object type
Binary In‐
put
Binary Out‐
put
Binary Val‐
ue
Analog In‐
put
Analog
Output
Analog
Value
Multi-State
Input
Octet
String Val‐
ues
Object_Identifier X X X X X X X X
Object_Name X X X X X X X X
Object_Type X X X X X X X X
Present_Value X X X X X X X X
Description X X X X X X X
Status_Flags X X X X X X X X
Event_State X X X X X X X
Out_Of_Service X X X X X X X
Units X X X
Advanced commissioning
6.2 Drive control
SINAMICS G120XA converter
186 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB