4. Remove 2 screws (TX-25).
5. Remove the fan.
6. Remove the fan from the mounting plate by loosening the 4 plastic screws.
The fan is removed.
❒
Installing the fan
1. Install the fan on the mounting plate by tightening the 4 plastic screws.
2. Align the fan to the screw holes.
3. Insert 2 screws (TX-25).
Tightening torque: 3 Nm
4. Plug the connector.
5. Install the front cover.
6. Insert 2 screws (TX-25) of the front cover.
Tightneing torque: 3 Nm
The fan is installed.
❒
Corrective maintenance
10.2 Replacing spare parts
SINAMICS G120XA converter
Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB 839
To Next Page
Loading...
