Siemens SINAMICS G120XA - Binary Output Objects; Binary Value Objects

Binary Output Objects
Instance
ID
Object name Description Possible val‐
ues
Text active /
text inactive
Access
type
Parameter
BO0 DO0 CMD Controls DO 0 (relay 1) ON/OFF ON/OFF C p0730
BO1 DO1 CMD Controls DO 1 (relay 2) ON/OFF ON/OFF C p0731
BO2 DO2 CMD Controls DO 2 (relay 3) ON/OFF ON/OFF C p0732
Binary value Objects
Instance
ID
Object name Description Possible values Text ac‐
tive
Text in‐
active
Ac‐
cess
type
Parameter
BV0 RUN / STOP
ACT
Converter status regardless of com‐
mand source
RUN / STOP STOP RUN R r0052.2
BV1 FWD / REV Direction of rotation regardless of
command source
REV / FWD FWD REV R r0052.14
BV2 FAULT ACT Converter fault FAULT / OK FAULT OK R r0052.3
BV3 WARN ACT Converter warning WARN / OK WARN OK R r0052.7
BV4 MANUAL /
AUTO ACT
Indicates the source of the manual/
auto converter control
AUTO / MAN‐
UAL
AUTO LOCAL R r0052.9
BV7 CTL OVER‐
RIDE ACT
ACT displays the converter's control
unit from the BACnet override con‐
trol unit via BV93.
Note that the operator panel's "Man‐
ual" operating mode has a higher
priority than the BACnet override
control.
ON/OFF 0 1 R r2032[10]
BV8 AT SET-
POINT
Setpoint reached YES / NO YES NO R r0052.8
BV9 AT MAX
FREQ
Maximum speed reached YES / NO YES NO R r0052.10
BV10 DRIVE
READY
Converter ready YES / NO YES NO R r0052.1
BV15 RUN COM
ACT
ACT indicates the status of the ON
command, regardless of the source
YES / NO 0 1 R r2032[0]
BV16 HIB MOD
ACT
ACT means that the converter is op‐
erating in energy-saving mode.
ON/OFF 0 1 R r2399[1]
BV17 ESM MOD ACT means that the converter is op‐
erating in the essential service mode
ON/OFF 0 1 R r3889[0]
BV20 RUN / STOP
CMD
ON command for the converter
(when controlling via BACnet)
RUN / STOP 0 1 C r0054.0
BV21 FWD / REV
CMD
Reverse direction of rotation (when
controlling via BACnet)
REV / FWD 0 1 C r0054.11
BV22 FAULT RE‐
SET
Acknowledge fault (when controlling
via BACnet)
RESET / NO 0 1 C r0054.7
BV24 CDS Local / Remote Local / Remote YES NO C r0054.15
BV26 RUN ENA
CMD
Enable converter operation ENA‐
BLED
DISA‐
BLED
C r0054.3
Advanced commissioning
6.2 Drive control
SINAMICS G120XA converter
188 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB