Siemens SINAMICS G120XA - Fieldbus Interface Bacnet Device Name; Bacnet Device Name; KHP Control Unit Reference Serial Number; KHP CU Ref Ser_No; KHP Control Unit Serial Number; KHP CU Ser_No

Dependency: See also: r0034, p0612, p0615, r0632, p5390
See also: F07011, F07013, A07014
NOTICE
When selecting a catalog motor (p0301), this parameter is automatically pre-assigned and is write protected.
Information in p0300 should be carefully observed when removing write protection.
Note
The hysteresis is 2 K.
p7610[0...78] Fieldbus interface BACnet device name / BACnet device name
Access level: 3 Calculated: - Data type: Unsigned8
Can be changed: T, U Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: 9310
Min:
-
Max:
-
Factory setting:
-
Description: Sets the object name for the BACnet device object.
This name must be unique within the complete BACnet network.
The object name is only preassigned with device name and serial number the first time that the system runs up, e.g.
"SINAMICS G120 CU230P-2 HVAC - XAB812-005806"
Note
An ASCII table (excerpt) can be found, for example, in the chapter of parameters.
r7758[0...19] KHP Control Unit serial number / KHP CU ser_no
Access level: 3 Calculated: - Data type: Unsigned8
Can be changed: - Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: Displays the actual serial number of the Control Unit.
The individual characters of the serial number are displayed in the ASCII code in the indices.
For the commissioning software, the ASCII characters are displayed uncoded.
Dependency: See also: p7765, p7766, p7767, p7768
NOTICE
An ASCII table (excerpt) can be found, for example, in the chapter of parameters.
Note
KHP: Know-How Protection
p7759[0...19] KHP Control Unit reference serial number / KHP CU ref ser_no
Access level: 3 Calculated: - Data type: Unsigned8
Can be changed: T Scaling: - Dynamic index: -
Unit group: - Unit selection: - Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description: Sets the reference serial number for the Control Unit.
Using this parameter, if a Control Unit and/or a memory card is replaced at the end customer, the OEM can again adapt
the project to the modified hardware.
Dependency: See also: p7765, p7766, p7767, p7768
Parameters
7.3 Parameters
SINAMICS G120XA converter
664 Operating Instructions, 03/2019, FW V1.0, A5E44751205B AB